QB50
available in either VDM (shown) using a manual hand
wheel for positioning of the CB (counterbend die), or VDE
model which incorporates motorized CB die positioning.
Maximum
capacity: up to 2" OD tube (mild steel, .125" wall
thickness). Wide range of bend radii available from 3/8" to
8-3/4" CLR.
Tooling
available to bend round, square, rectangular tube, and
profiles or special shapes.
Variable bending speed: adjusted by potentiometer on
control panel (>/=11.5
seconds for 180°). Allows operator to set required speed for
various material; i.e stainless and chromoly require slow
speed settings.
Microprocessor Control Unit: bending angle, springback
factor, and zero position of counterbend die shaft (VDE model
only) are fully programmable and monitored thru the control
panel.
User
friendly programming: easy step by step method. Capable of
storing up to 10 sequential bends.
Electronic overload device: automatically protects the
mechanical system from possible damage caused by oversized
material and / or excessive bend speed.
Multilanguage control panel with backlit LCD display
enhances ease of operating and programming.
Low
maintenance: requires lubrication of counterbend die only.
Quick
change tooling.
Portable: built in wheels and extractable handles.
Available in single phase, or three phase with multiple
voltage settings.
Positioning Table available (QPPT)
QB-76 VDM,
QB-76 VDE
Maximum
capacity: up to 3" OD (.125" wall); bend radii up to
15-3/4".
QB76
available in either VDM using a manual hand wheel for
positioning of the CB (counterbend die), or VDE model
(shown) which incorporates motorized CB die positioning.
Variable bending speed: adjusted by potentiometer on
control panel (>/=21.5
seconds for 180°). Allows operator to set required speed for
various material; i.e stainless and chromoly require slow
speed settings.
QB-76
VDE/S model available when higher speeds are required;
capacity is same, bend speed is 2.5 times faster.
Tooling
available to bend round, square, rectangular tube, and
profiles or special shapes.
Microprocessor Control Unit: bending angle, springback
factor, and zero position of counterbend die shaft (VDE model
only) are fully programmable and monitored thru the control
panel.
User
friendly programming: easy step-by-step method. Capable of
storing up to 10 sequential bends.
Electronic overload device: automatically protects the
mechanical system from possible damage caused by oversized
material and/or excessive bend speed.
Multilanguage control panel with backlit LCD display
enhances ease of operating and programming.
Low
maintenance: requires lubrication of counterbend die only.
Quick
change tooling.
Portable: built in wheels and extractable handles.
Available in single phase, or three phase with multiple
voltage settings.
